Bitmain Power Supply Fan

There are a total of 10 plugs coming from the power supply so there will be one extra unused plug.

Bitmain power supply fan.

In stock new antminer s9 13 5t bitcoin miner asic btc bitmain mining machine with power supply. 80 89 v a c. 1 check whether the power supply and power cables are plugged in and powered 2 measure with a multimeter for whether the power supply 6pin line has 12v output 3 check the control board and the hashboard for burnout marks. 95 105 v a c.

Re plug the line 2. Power factor 0 95 full load leakage current 1 5 ma 220 v 50 hz protection low voltage input. The bitmain power supply works well for us residents. Replace the control board.

View return policy. If gauge is too low it will not power the supply only the fan within. This is because it is in high temperature protection mode. In stock new antminer s9 13 5t bitcoin miner asic btc bitmain mining machine with power supply.

Plug 6 pin 12v plugs from the bitmain power supply to the 8 positions on the hash boards and the one position on the control board. Psu repeatedly stops for a few seconds then resumes. Apw7 is a new power supply model released by bitmain especially for our antminers. Check if power supply s output has been short circuited or overloaded.

Power off protection trip time 9 ms. 47 63 hz. 2 x 12038 fan. I have 16 miners of all types the bitmain psu s are great.

2 x 12038 fan over voltage protection. This power supply is an upgraded version of apw3 and it has few technology advantages compared to our apw3. Nema 6 15p to c13 power cord 6ft 250 220v cable for bitmain antminer apw3 apw7 power supply digital ballast cord industrial use u l certified and csa approved 14awg 15a 4 7 out of 5 stars 23 15 99 15. Yes over load protection.

5 pairs of 6 pin pcie connectors 10 connectors noise level 43 db input voltage range. Power off the psu for 10 minutes then resume. Replace the faulty power supply 3. View return policy 6 976 00.

Then plug in the power supply to the outlet pigtail. 2 rear fans size. Cannot scan the miner. Plug in the ethernet cable to the antminer.

This would cause the power supply to the protection mode. I highly recommend using a higher gauge power cord with it especially if using it to power a s9 t9 a3 or d3 220 volts.